Originally Posted by philip_r5
Depending on where you are, I'd like to use it next.
Depending on where you are, I'd like to use it next.
I'm in Downtown Orlando. I'd like to wait on my upgraded Gen3 Pro Radion before I complete my testing - my old unit will be @ ecotech tomorrow at 3pm.
PS - Any pointers on how to best use this in the tank? IE - do you use a stick/plastic dowel to measure in the tank?
Does anyone have a link for a PAR reference? I found one the other day - it was a very cool chart that listed corals by PAR requirements. It had a slider with the PAR value, and then on the right hand side, it'd display corals that'd thrive.
Anyone know where I can find a PAR reference? Thanks!
JBJ 30 RL | View Bob's 30 Nano build on RC
That's fine with me. I'm in no hurry. Just let me know when you're done. I had the meter a few months ago and it came with an acrylic strip someone made to hold the sensor. I'm guessing you don't have that?
Sent from my iPhone using Tapatalk
No sir. Any good PAR references you recommend?
JBJ 30 RL | View Bob's 30 Nano build on RC
Basically all I did was take a picture of the tank and write the values on the photo. I did this a few times at different intensities. Each value is where I placed the sensor as close to the surface of the aquascape as I could.
Sent from my iPhone using Tapatalk
Thanks, I did the same for my scape. Not quite as precise because I was using my aqua tongs to hold the meter... LOL
I'm ready to hand it off if you're ready for it!
JBJ 30 RL | View Bob's 30 Nano build on RC
Posting Permissions
 |
 |
|
Reply With Quote
Bookmarks